Gather your supplies
- Measuring tape
- Mitre box
- Tasmanian oak dowel 1.8m x 22mm-dia (1)
- 90-degrees 25mm x 25mm copper capillary elbows (4)
- 25mm x 25mm x 25mm copper capillary tees (4)
- Hot glue gun and glue sticks (optional)
- White taper candles (4)
Measure and use pencil to mark dowel into 8 lengths of 120mm. Use handsaw and mitre box to neatly cut each piece at marked positions.
Using this picture as a guide, assemble candelabra by slotting ends of dowel into the copper components. Elbows go in the corners, while tees go between each two side lengths. If you wish, you can add a dab of hot glue to the end of each dowel before slotting into the copper components to help secure the assembly while you fit it together.
Slot the final length of dowel into the candelabra assembly and trim the dowel a little shorter for a snug fit if necessary. Place candles in the upward-facing openings of the tees. If required, use a utility knife to shave down the ends of the candles and place them in the openings.
1. If you choose copper elbows and tees of a narrower or wider diameter, simply adjust the diameter of the dowel to suit.
2. You can adjust the finished shape from a square to a rectangle by shortening the dowel lengths at two ends and lengthening the dowel along the remaining two sides.
3. Mix up the look by using near-straight dried tree branches – just whittle the ends to allow a neat fit within the copper components.